Environmental Impacts of Small Dams on Agriculture and Ground Water Development: A Case Study of Khanpur Dam, Pakistan

Article Sidebar

PDF
Published: Jun 22, 2016

Main Article Content

Naeem Ejaz
Usman Ali Naeem
Muhammad Ali Shahmim
Ayub Elahi
N. M. Khan

Abstract

The water scarcity issues are increasing through out the world. Pakistan is also facing water crises and its water demands are increasing every day. During this research it is investigated that small dams are playing an important role for the sustainability of groundwater and agriculture. The main objective of this study was to assess the environmental impacts of small dam on agricultural and ground water. Proper planning and management of small dams may improve the sustainable agriculture in Pakistan. It is also concluded that small dams are significantly contributing towards economy, environment, local climate, recreational activities and crop production. Small dams can also be utilized for the production of electricity at local level. On the other hand, water management issues can be resolved by the involvement of local farmer’s associations. Water losses through seepage, unlined channels and old irrigational methods are most critical in developing world. Considering the overall positive environmental impacts, construction of small dams must be promoted.

Article Details

Issue
2012: Volume 10 JAN 2012
Section
City and Regional Planning, Environmental Engineering, Architecture

References

ASTM D 6635; Standard Test Method for Performing the Flat Plate Dilatometer Test (2003).

S. Marchetti, P. Monaca, G. Totani, and M. Calabrese; The Flat Dilatometer Test (DMT) in Soil Investigation, Report of the ISSMGE TC-16 on Ground Property Characterization from Insitu Testing (2001).

A. Akbar; Development of Low Cost In-Situ Testing Devices, PhD Thesis, University of Newcastle Upon Tyne, UK (2001).

M. Arshad; Development of Correlations among Various Site Characterization Methods, M. Engg. Thesis, UET, Lahore, Pakistan (2008).

M. Aziz; Calibration of Newcastle Dilatometer in Cohesive Soils, M. Engg. Thesis, UET, Lahore, Pakistan (2006).

A. Bashir; Compressibility Characteristics of Southern Lahore Alluvium Using Newcastle Dilatometer, M. Engg. Thesis, UET, Lahore, Pakistan (2005).

S. Kibria; Evaluation of In-situ Characteristics of Southern Lahore Alluvium using Newcastle Dilatometer”, M. Engg. Thesis, UET, Lahore, Pakistan (2004).

H. Nawaz; Analysis of Newcastle Dilatometer Testing Data for Jaranwala Sandy Subsoils”, M. Engg. Thesis, UET, Lahore, Pakistan (2005).

A. Akbar and B. G. Clarke; A Flat Dilatometer to Operate in Glacial Tills, ASTM-Geotechnical Testing Journal, (2001) 24(1): 51-60.

A. Akbar and B. G. Clarke; In-Situ Pore Pressure Measurement Using Newcastle Research Dilatometer.” Research Journal UET, Lahore, Pakistan (2002) Volume - 13: 133-151.

A. Akbar, S. Kibria and B. G. Clarke; The Newcastle Dilatometer Testing in Lahore Cohesive Soils, 16th ICSMGE International Conference, Osaka, Japan (2005).

A. Akbar, H. Nawaz, and B. G. Clarke; The Newcastle Dilatometer Testing in Pakistani Sandy Subsoils, 2nd International Conference on the Flat Dilatometer, April 2-5, 2006, Washington, D.C, USA (2006).

A. Akbar, M. Aziz, K. Farooq and B. G. Clarke; Characterisation of a Cohesive Soil Test Bed Using Akbar Newcastle Dilatometer, 13th Asian Regional Conference on Soil Mechanics & Geotechnical Engineering, Kolkata, India (2007).

A. Akbar, M. Arshad and B. G. Clarke; Site Characterisation using CPT, DMT, SPT and Laboratory Testing Results, 3rd International Conference on Site Characterization, April 1-4, 2008, Taipei, Taiwan (2008).

S. Marchetti; In Situ Tests by Flat Dilatometer, Journal of Geotechnical Engineering – ASCE (1980) Vol. 106, No. GT 3, pp 299-321.

A. J. Lutenegger; Current Status of the Marchetti Dilatometer Test, Proceedings of 1st International Symposium on Penetration Testing, ISOPT-1, Florida, USA (1988) Vol.1, pp 137-155.

S. Lacasse and T. Lunne; Calibration of Dilatometer Correlations, Proceedings of the 1st International Symposium on Penetration Testing, ISOPT-1, Florida USA (1988) Vol. 1, pp 539- 548.

J. H. Schmertmann; A Method for Determining the Friction Angle in Sands from the Marchetti Dilatometer Tests, Proc. 2nd European Symposium on Penetration Testing, ESOPT-II, Amsterdam, Holland (1982) Vol. 2, pp. 853-861.

S. Marchetti and D. K. Crapps; Flat Dilatometer Manual, GPE Inc., USA (1981).

ASTM D 5778; Standard Test Method for Performing Cone Penetration Test in Soils (1995).

ASTM D 2435; Standard Test Methods for One Dimensional Consolidation Properties of Soils using Incremental Loading (2004).

P. W. Mayne; Cone Penetration Test – State of Practice, NCHRP Synthesis, Transportation Research Board, Washington DC, USA (2007).

P. K. Robertson; Soil classification using the cone penetration test, Canadian Geotechnical Journal (1990), 27 (1), 151-8.

P. W. Mayne, J. Puechen and D. Bouwmeester; Estimation of soil unit weight from CPT’s, Proceedings of 2nd International Symposium on Cone Penetration Testing, CPT’10, Huntington Beach, CA, USA (2010), Vol. 2, 169-176.