Influence of Heat Treatment on the Autocatalytic Ni-P and Ni-Co-P Deposits

Article Sidebar

PDF
Published: Jun 22, 2016

Main Article Content

A. Ahmad
K.M. Ghauri
L. Ali
A. A. Noshahi
J. P. G. Farr

Abstract

Autocatalytic or electroless deposition is the process of depositing a coating by means of a reducing agent in solution without using electric current. Deposits so produced are primarily alloys of metal(s) with a non-metal like phosphorus or boron. Addition of a non-metal in the metallic lattice may change the metallic crystalline structure to amorphous or microcrystalline that in turn affects the properties such as wear resistance, hardness and corrosion resistance. This paper presents the electroless deposition of Ni-P and Ni-Co-P films using hypophosphite-based baths. The effects of plating parameters like bath composition, temperature, pH and heat treatment at different temperatures have been discussed. The deposits were explored for their magnetic and electrochemical behaviour. The chemical analysis of the deposits was carried out using energy dispersive X-ray analysis (EDX) and TEM. The crystal structure was determined using X-ray diffraction analysis (XRD). The magnetic properties were measured with the help of a vibrating sample magnetometer (VSM). A potentiostat was used to carry out linear sweep voltametery. The results showed that the bath temperature and the pH strongly affect the chemical composition and characteristics of the deposits. The deposits are microcrystalline in the as-deposited condition and recrystallize at 300- 3500 o C. However, the corrosion resistance of the deposits decreased after the heat treatment due to formation of different anodic phases.

Article Details

Issue
2013: Volume 12 JAN 2013
Section
Polymer Engineering and Chemical Engineering, Materials Engineering, Physics, Chemistry, Mathematics

References

Ahmed K. and Tariq N.M., “Ravi-River A Biological Survey”, Institute of Public Health Engineering & Research, Report No. 042-06-79, Univ. of Engg., & Tech., 1979, Lahore.

Ali R.M., “A field study of fecal streptococci in the River Ravi”, Institute of Public Health Engineering & Research, Report No. 041-06-79, Univ. of Engg., & Tech., 1979, Lahore.

APHA, “Standard Methods for the Examination of Water and Wastewater”, 20th Edition, American Public Health Association, 1998, Washington, DC20005-2605.

Bowie, et.al., “Rates, constants, and kinetics formulation in surface water quality modeling”, 2 nd Editions, USEPA/600/3-85/040, 1985, Athens, GA.

Chapra S.C., “Surface water quality modeling”, McGraw Hill International, Civil Engineering Series, 1997, Singapore.

Chick, H., “An investigation of the laws of disinfection”, J. Hyg. (Lond), 8(1), 92–158, 1908.

City of New York, “Areawide water treatment management planning program”, Section 208, NYC Dept. of Env. Prot., 8 Chapters, 1979.

Connolly et.al., “Modeling fate of pathogenic organisms in coastal waters of Oahu”, Hawaii, Journal of Environmental Engineering, 125(5), 398–406, 1999.

Elshorbagy, A., and Ormsbee, L., “Objectoriented modeling approach to surface water quality management”, Environ. Modell. Software, 21, 689–698, 2006.

EPD – Punjab, “Installation of Wastewater Treatment Plants to save River Ravi from Pollution”, District Sheikhupura, Environmental Protection Department, 2009, Lahore.

Government of the District of Columbia, “Water quality standards for interstate waters of the District of Columbia”, Department of Env. Serv, Env. Health Admin., Bureau of Air and Water Quality, Water Hygiene Division, 16 pp., 1981.

Haider H., “Water Quality Management Model for Ravi River”, PhD Thesis, Institute of Environmental Engineering and Research, UET, 2010, Lahore.

Haider H, Ali W., “Development of Dissolved Oxygen Model for a Highly Variable Flow River: A Case Study of Ravi River in Pakistan”, Environmental Modeling and Assessment Journal, 15 (6): 583-599, 2010a.

IPHER, “Ravi River Pollution Study-III”, IPHER, Report No. 040-03-79, Univ. of Engg., & Tech., 1979, Lahore.

Kittrell B.A., and Furfari S.A., “Observation of coliform bacteria in streams”, Journal of Water Pollution Control Federation, 35, 1361-1385, 1963.

Manache G., Meching C.S., and Lanyon R., “Calibration of a Continuous Simulation Fecal Coliform Model Based on Historical Data Analysis”, Journal of Environmental Engineering, 133(7), 681-691, 2007.

Mancini J. L., “Numerical estimates of coliform mortality rates under various conditions.” Journal of Water Pollution Control Federation, 50(11), 2477–2484, 1978.

Shah M., “Fecal Coliform Modeling of Ravi River”, MSc Thesis, IEER, UET, 2009, Lahore.

Thomann V. R and Mueller A.J, “Principles of Surface Water Quality Modeling”, Harper International Edition, Harper & Row, 1987, New York.

WHO, “Health Guidelines for the use of wastewater in agriculture and aquaculture”, Geneva, WHO Technical Report Series, No. 778, 1989.